Merging OFW | Suffering | Part 1 | Wont build as is

I honestly dont even know anymore...

applications/examples/example_thermo/README.md

@@ -0,0 +1,44 @@
+# 1-Wire Thermometer
+This example application demonstrates the use of the 1-Wire library with a DS18B20 thermometer. 
+It also covers basic GUI, input handling, threads and localisation.
+
+## Electrical connections
+Before launching the application, connect the sensor to Flipper's external GPIO according to the table below:
+| DS18B20 | Flipper |
+| :-----: | :-----: |
+| VDD | 9 |
+| GND | 18 |
+| DQ  | 17 |
+
+*NOTE 1*: GND is also available on pins 8 and 11.
+
+*NOTE 2*: For any other pin than 17, connect an external 4.7k pull-up resistor to pin 9.
+
+## Launching the application
+In order to launch this demo, follow the steps below:
+1. Make sure your Flipper has an SD card installed.
+2. Connect your Flipper to the computer via a USB cable.
+3. Run `./fbt launch_app APPSRC=example_thermo` in your terminal emulator of choice.
+
+## Changing the data pin
+It is possible to use other GPIO pin as a 1-Wire data pin. In order to change it, set the `THERMO_GPIO_PIN` macro to any of the options listed below:
+
+```c
+/* Possible GPIO pin choices:
+ - gpio_ext_pc0
+ - gpio_ext_pc1
+ - gpio_ext_pc3
+ - gpio_ext_pb2
+ - gpio_ext_pb3
+ - gpio_ext_pa4
+ - gpio_ext_pa6
+ - gpio_ext_pa7
+ - ibutton_gpio
+*/
+
+#define THERMO_GPIO_PIN (ibutton_gpio)
+```
+Do not forget about the external pull-up resistor as these pins do not have one built-in.
+
+With the changes been made, recompile and launch the application again. 
+The on-screen text should reflect it by asking to connect the thermometer to another pin.