rayhunter/doc/moxee.md

KonnectONE Moxee Hotspot (K779HSDL)

Supported in Rayhunter since version 0.6.0.

The Moxee Hotspot is a device very similar to the Orbic RC400L. It seems to be primarily for the US market.

These devices have relatively little storage. The Orbic is usually a better alternative, though might be more expensive.

• KonnectONE product page
• Moxee product page

Supported bands

According to FCC ID 2APQU-K779HSDL, the device supports the following LTE bands:

Band	Frequency
2	1900 MHz (PCS)
4	1700/2100 MHz (AWS-1)
5	850 MHz (CLR)
12	700 MHz (Lower SMH)
13	700 MHz (Upper SMH)
25	1900 MHz (Extended PCS)
26	850 MHz (Extended)
41	2500 MHz (TDD)
66	1700/2100 MHz (E-AWS)
71	600 MHz

Installing

To get started, follow the release installation guide. Then run the installer with the following command:

./installer moxee --admin-password 'mypassword'

# Note: the arguments --admin-username 'myusername' and --admin-ip 'mydeviceip'
#       may be required if different from the default.

• The password is the one used to log in to the device's admin menu. You can reset the password by pressing the button under the back case until the unit restarts.
  • Note: If you have changed the device username, password, or IP address from their default values, these must be provided as arguments to the installer command above.
• On Moxee-brand devices, check under the battery for the password.
• ./installer moxee is almost the same as ./installer orbic, it just comes with slightly better defaults that will give you more space for recordings.

The Rayhunter UI will be available at http://192.168.1.1:8080.

Obtaining a shell

After running the installer, there will not be a root shell and ADB will not be enabled. Instead, you can use:

./installer util orbic-shell